初级表友
- 认证:
-
购买地:瑞士
腕表型号:欧米茄海马300米潜水表玫瑰金胶带
购买价格:35000人民币
点击查看该作业贴 >>
勋章:
|
59208
浏览
/
29
回复
宝珀正装机芯停秒的正确操作
发表于浙江杭州 2019-11-24 09:22:10
|
显示全部楼层
本帖最后由 cephyr 于 2019-11-24 09:53 编辑
宝珀的正装表有很大一部分都是以FP1150作为基础机芯,包括6654、6651等等绝大部分全都是。这个机芯是一个1988年的超薄机芯,其中一个特点是没有停秒。
这几天看有很多人询问如何把秒针和分针对齐。其实掌握技巧是可以调齐的,就是麻烦点。方法就是反向给表冠施加一个力,就可以停秒了,先把秒针停在12点位,然后等分针走过来时按下表把,秒针和分针就齐了。多练习会更熟练,对表没有伤害。需要注意的是最好不要半夜切日历的时候这样做,当然做了也不至于损坏表,但不是太好。
以上信息来自原厂给外国表友的邮件回复。原文:
So Ive seen lots of debate as to whether its bad for a watch if you move the hands counter-clockwise to set it, for instance, when you travel west through different time zones, and also whether its bad to hack a non-hacking movement by keeping pressure on the crown just enough for the seconds hand to stop. Consensus seemed to be neither was bad for most watches, but making the seconds hand actually run backwards could be bad, potentially chipping pallet stones.
When I got my Breguet Marine, which has an F. Piguet 1150 movement that does not hack (modified by Breguet to run at 28,800 instead of 21,600), I was reluctant to move the hands backward or to hack it, so I emailed Breguet. It took a couple of weeks, but I did get the following response, which I post here in case others are curious as to their answer: ''Following your request, we are pleased to inform you that turning the hands backwards on your Breguet time piece has no negative effect on the movement as long as the hands do not pass over midnight. Indeed passing midnight backwards can cause some strain in the date mechanism, although there are securities to avoid any permanent damage, this is not recommended. Stopping the second hand by turning the hands backwards or just by holding them back has no lasting negative effect on the watch either, as soon as the crown is pushed back in or the hands turned forward the watch will run again as it did before.'' So, there you have it, at least for thi**ovement.
|
|